Stiga T8562 Manual Del Usuario página 4

NOTE: If casters came pre-assembled
on Caster Beam (#8), skip to Step 2.
1. Slide a Caster Wheel with Lock (#13) into Caster Beam
as shown in FIGURE 1. On the other end of the Caster
Beam attach a Caster Wheel without Lock (#9). Make
sure you have one Caster Wheel with lock and a Caster
Wheel without lock for each Caster Beam.
Repeat this step to attach the Casters to the second
Caster Beam.
Parts Needed:
2 pcs - #8 Caster Beam
2 pcs - #9 Caster without lock
2 pcs - #13 Caster with lock
8
2. Attach Cross Tube (#7) to Caster Beam Assemblies (#8) using four Thumb Screws (#26) as shown
in FIGURE 2.
Part Needed:
1 pc - #7 Cross Tube
Hardware Needed:
4 pcs - #26 Thumb Screw
NOTE: Assemble with
threaded insert facing down.
8
with lock
9
without lock
13
7
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
AND SAFETY INSTRUCTIONS CAREFULLY . AT LEAST
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
13
Rubber Hammer
with
lock
26
4
9
8
NOTE:
Make sure the Caster
Stem is completely installed
into Caster Beam as shown.
13
without lock
Figure 1
Figure 2