Stiga T8562 Manual Del Usuario página 6

4. A) Attach two Square Legs (#1) between Leg Mounting Brackets (#23) and Leg Mounting Bracket &
Brace Assemblies (#6) using two Hex Head Bolts (#21), four Plastic Flat Washers (#24)
and two Locknuts (#14) as shown in FIGURE 4 & DETAIL A.
Attach middle holes of two Square Legs (#1) to Leg Mounting Bracket & Brace Assemblies (#6)
using two Phillips Rd. Hd. Bolts (#17), two Flat Washers (#37) and two Locknuts (#19) as shown in
FIGURE 4 & DETAIL A.
B) Install one Hex Nut (#27) to each Leg Leveler
(#28). Then install Leg Levelers to Square Legs
as shown in FIGURE 4.
Repeat for other Table Top.
Hardware Needed:
2 pcs - #14 Locknut
2 pcs - #17 Phillips Rd. Hd. Bolt
2 pcs - #19 Locknut
2 pcs - #21 Hex Head Bolt
4 pcs - #24 Flat Plastic Washer
2 pcs - #27 Hex Nut
2 pcs - #37 Flat Washer
Parts Needed:
2 pcs - #1 Square Leg-Silver
1 pc - #2 Aluminum Top Assembly
2 pcs - #28 Leg Leveler
37
17
21
28
27
1
19
14
24
6
23
DETAIL A
37
17
21
23
NOTE:Hole is not on center and
must be assembled as shown with
offset hole toward middle of table.
Middle of table is
end without stripe.
6
1
19
14
24
6
Do not use
bottom two holes.
Figure 4