Stiga T8562 Manual Del Usuario página 5

3. Attach four Strut Tubes (#4) and four Linkage Tubes
(#25) to Caster Beam Assembly using four Carriage
Bolts (#10), four Spacers (#11) and four Locknuts (#14)
as shown in FIGURE 3.
Snug, but do not overtighten the #14 Locknuts as
this is a pivot point.
NOTE: make sure
linkage and Strut tube
are turned as shown.
25
10
NOTE: make sure
linkage tube is arched
in this direction.
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
Hardware Needed:
4 pcs - #10 Carriage Bolt
4 pcs - #11 Spacer
4 pcs - #14 Locknut
Parts Needed:
4 4 pcs - #4 Strut Tube
4 pcs - #25 Linkage Tube
14
11
5
Figure 3
NOTE: make sure
linkage tube is arched
in this direction.