Stiga T8562 Manual Del Usuario página 8

6. A) Attach U-Support (#3) and Strut Tubes (#4) using two Phillips Rd. Hd. Screws (#15) as shown in FIGURE 6.
Note: If hinge (#5) is positioned as shown in DETAIL B, you will have to rotate the hinge to the position shown in Detail C.
DO NOT unscrew the hinge, you can rotate the hinge without unscrewing it from the table. If you want to see a video on how
to position Hinge (#5) go to:
B) Attach Long Hinge & Mounting Bracket Assemblies (#5) to Strut Tubes (#4) using two Bolts (#12), two Spacers (#11), two Flat Plastic
Washers (#24) and two Locknuts (#14) as shown in FIGURE 6 & DETAIL C.
Tighten Nuts snug, but DO NOT OVERTIGHTEN, hinges must pivot. CAUTION: Hinges must be positioned exactly as shown or
table will not operate correctly and could be damaged. DO NOT take Hinges off.
C) Attach Linkage Tubes (#25) to Square Legs (#1) using two Hex Head Bolts (#20), two Flat Plastic Washers (#24), two Spacers
(#11) and two Locknuts (#14) as shown in FIGURE 6.
D) Attach two Corner Protectors (#29) to Top Assembly using four Screws (#15) with four Washers (#37) as shown in FIGURE 6.
Repeat for other Table Top.
Hardware Needed:
4 pcs - #11 Spacer
2 pcs - #12 Phillips Rd. Hd. Bolt
4 pcs - #24 Flat Plastic Washer
4 pcs - #14 LockNut
ATTENTION: If hinge is positioned as shown
below (DETAIL B), rotate the hinge as shown in
DETAIL C. Do not take hinge off.
DETAIL B
INCORRECT POSITION OF HINGE
CAUTION: Position hinges exactly as
shown in DETAIL C or table will not
operate correctly and could be damaged.
4
12
DETAIL C
5
CORRECT POSITION OF HINGE
In the correct position Hinge (#5) will look
like a "V" when attached to Strut Tube (#4).
http://www.escaladesports.com/customer-service/videos.html
6 pcs - #15 Phillips Rd. Hd. Screw
4 pcs - #37 Washer
2 pcs - #20 Hex head Bolt
5
4
14
24
11
12
Part Needed:
2 pcs - #29 Corner Protector
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE INSTALLED!
DO NOT LEAVE TABLE STANDING
UN ATTENDED. IT COULD BE KNOCKED
OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.
29
37 15
4
5
8
1
14
3
25
15
14
24
11
NOTE: Tighten screws snug, but do not
overtighten, causing screws to strip in
metal tube.
20
24
11
Figure 6