Metabo HPT N 1804DA Instrucciones Y Manual De Seguridad página 20

English
[Auto power off ]
When the power is turned on but the Stapler
is not used for 30 minutes, the Stapler is
automatically turned off . To turn on again, press
the power switch.
Never leave the Stapler with the power on. This
could result in an accident.
Stapling operation indicator
● Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM
● Blinking (Blue):
CONTACT ACTUATION MECHANISM
Make sure the battery indicator is not lighting or
blinking.
If the battery indicator is lighting or blinking in red, the
battery doesn't have enough power and it needs to be
charged.
(4) Remove the fi nger from the trigger and press the
push lever against the workpiece.
□ THE STAPLER MUST NOT OPERATE.
Do not pull the
trigger
Depress
push lever
(5) Separate the push lever from the workpiece.
Next, point the stapler downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□ THE STAPLER MUST NOT OPERATE.
Pull the trigger
20
WARNING
[Time out function]
When set in contact actuation mode, pull and
hold the trigger for at least 2 seconds to enter
time out mode.
Or when set in full sequential mode, press
and hold the push lever for at least 4 seconds
to enter time out mode. The LED will blink to
indicate time out mode.
The stapler is disabled in time out mode.
To return to normal mode, release the trigger or
lift the tool off the wood surface.
LED light
(6) Without touching the trigger, depress the push
lever against the workpiece.
Next, pull the trigger.
□ THE STAPLER MUST OPERATE.
Hold the trigger back and depress the push
lever against the workpiece again.
□ THE STAPLER MUST NOT OPERATE.
Separate the fi nger from the trigger.
Next, is operated again.
□ THE STAPLER MUST OPERATE.
(7) Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE STAPLER MUST NOT OPERATE.