Before Operation; Preparing The Battery - Metabo HPT N 1804DA Instrucciones Y Manual De Seguridad

● When the pilot lamp fl ikers rapidly in red (at
0.2–second intervals), check for and take out
any foreign objects in the charger's battery
installation hole. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.

BEFORE OPERATION

Read section titled "SAFETY" (pages 3–10).
Make sure of the followings before operation.

PREPARING THE BATTERY

Read section titled "SAFETY, IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY CHARGER" (page 7).
You must charge the battery before use.
The charging method of battery is shown in
pages 15–17.
HOW TO OPERATE OPERATION
PANEL
Stapling operation
indicator
Stapling operation
switch
(1) Power switch ON
Under the condition of "Power switch OFF", push
and hold on Power switch more than 1 second, then
power indicator lights in Green.
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
Power indicator
Battery indicator
Power
switch
OFF
ON
(2) Power switch OFF
Under the condition of "Power switch ON", push
and hold on Power switch more than 1 second, then
power indicator goes off .
Under the condition of "Power switch ON", functions
below are active.
(3) Select Stapling operation mode
(Full sequential actuation / Contact actuation)
After power switch turn ON, always set in Full
sequential actuation mode as initial. (Stapling
operation indicator light in blue.)
Light in blue
To change stapling operation mode, push Stapling
operation switch once. Every pushing, mode will
change between "Full sequential" and "Contact".
Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM,
Blinking (Blue):
CONTACT ACTUATION MECHANISM
Blink in blue
English
Light in green
17