Adjusting The Stapling Depth; Using The Hook - Metabo HPT N 1804DA Instrucciones Y Manual De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
● Keep your fi nger off the trigger except during
stapling operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT stapler may
bounce from the recoil of driving a staple and
unwanted subsequent staple may be driven,
possibly causing injury.
NOTE
● If all warnings and instructions are followed,
safe operation is possible with all two systems:
FULL SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
● Always handle staples and package carefully. If
staples are dropped, collating bond may be broken,
which will cause mis-feeding and jamming.
● After stapling:
1) remove battery from the Stapler;
2) remove all staples from the Stapler;

ADJUSTING THE STAPLING DEPTH

To assure that each staple penetrates to the same depth,
be sure that the Stapler is always held fi rmly against the
workpiece.
If staples are driven too deep or shallow into the
workpiece, adjust the stapling in the following order.
Remove the battery from the Stapler.
24
WARNING
Battery
If staples are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in half-turn increments.
Too Deep
Too Shallow
If staples are driven too shallow, turn the adjuster to
the deep side.
Stop turning the adjuster when a suitable position is
reached for a stapling test.
Connect the battery to the Stapler.
ALWAYS WEAR SAFETY GLASSES.
Perform a stapling test.
Remove the battery from the Stapler.
Choose a suitable position for adjuster.

USING THE HOOK

● When using the hook, turn off the power
switch (green light "OFF"). Pay suffi cient
attention so that the main equipment does
not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips
screw driver.
Turn Adjuster
Flush
Turn Adjuster
Flush
WARNING
Groove
Hook
Screw

Publicidad

Tabla de contenido
loading

Tabla de contenido