Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
•
To switch the appliance off, depress the button a third
time.
Figure F
POWERBOOST mode
The green LED will illuminate when the appliance is in
POWERBOOST mode. The vacuum will operate at a higher
suction level to pick up debris that requires more power.
Filter sensor
Whenever a filter is blocked and needs cleaning, the red
LED in the handle will illuminate. Clean dust from filter (See
"Cleaning the Dust Bowl and Filter" section).
Nozzle / Accessories
•
A crevice tool
4
is built into the nozzle
crevice tool as shown in Figure G, until it clicks in place.
•
To shorten the crevice tool, depress the crevice tool
release button
as shown in Figure H and slide the
5
crevice tool into the nozzle.
Figure G
Figure H
Attaching the pet head (Fig. I)
•
Slide the nozzle
3
into the opening of the motorized
pet head
18
, ensuring that the connectors
with the recesses
21
4
3
. Extend the
20
. An audible click will be heard.
Figure I
18
D
Detaching the pet head (Fig. J)
•
Push the motorized pet head release button
•
Lift the main unit from the pet head
Figure J
Removing the beater bar from the pet
head (Fig. K)
•
Press the beater bar release button
•
Lift the beater bar
•
The beater bar can now be freed from any hair and
accumulated debris.
Figure K
AUTOSENSE
The appliance is fitted with a unique floor sense feature.
It will automatically switch between low and high mode
when you are vacuuming between a hard floor and a thick
pile carpet.
•
To operate the floor sense feature, depress the power
button (
1
detect the service that is being vacuumed.
NOTE: Once the power button is depressed twice, the
vacuum will only operate in BOOST mode.
Removing and clearing the beater bars
engage
•
Depress the beater bar release button
Figure L.
3
20
22
23
up and out of the pet head.
22
or
12
) once. The feature will automatically
21
19
.
.
13
19
.
23
24
as shown in
Publicidad
Tabla de contenido
