Cleaning And Storage - Honeywell HS-120 Serie Manual Del Propietário

• Place your fan on a
level and dry surface.
• Plug the power cord
into a 120 volt wall outlet.
• To operate the Child
Resistant switch, push in
and turn the Speed
Control Knob (Fig. 8).
Fig. 8
PUSH
IN AND
TURN
• Turn the Speed Control
Knob to OFF.
• Tilt the fan motor
assembly back so that
the front grille of the fan
is facing the ceiling.
• Turn the fan to the OFF
position and unplug the
fan before cleaning.
• Remove the Front Grille.
• Unscrew the
Blade Knob by
turning it CLOCKWISE.
• Pull the Fan Blade away
from the Motor Housing.
• Clean the Fan Blade
• To stop the oscillating
feature, pull up hard on
the Oscillation Control
Knob. You will feel two
clicks before oscillation
stops (Fig. 9).
• To re-start oscillation
push down on oscillation
knob.
Fig. 9
USING YOUR FAN AS AN AIR CIRCULATOR
• DO NOT USE
OSCILLATION FEATURE
IN THE AIR CIRCULATOR
POSITION.
and grilles with a soft,
damp cloth.
• DO NOT immerse the
fan in water and never
allow water to enter the
Motor Housing.
• DO NOT use gasoline,
paint thinner or other
chemicals to clean
the fan.
OSCILLATION
CONTROL KNOB

CLEANING AND STORAGE

OPERATION
• Turn the Speed Control
Knob to your desired
speed.
• To store, disassemble
and clean the fan
carefully as instructed
and store it in its original
box. You may leave the
fan assembled and
covered to protect it from
dust. Store the fan in a
cool, dry place.