Cleaning And Storage - Honeywell HFS-641PC Guide D’utilisation

REMOTE
The remote control can be used up to 26 feet (8M) away
from the fan. Be sure to point remote directly at the front of
the fan to ensure a proper response.
• To remove remote from the fan, slide it up and lift it off the
front panel. To place remote back on the fan, slide it down
the track around the fan's control panel and press gently to
snap in place.
• The button on the remote will respond in the same manner as the buttons on
the fan. To review these features see "operation" and "features" portion of the
owners manual.
• You will hear a "beep" from the fan and see illuminated lights on the fan
control panel while using the remote. This shows you that the remote is
working.

CLEANING AND STORAGE

• Turn the fan to the off position and unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the fan clean.
• DO NOT immerse the fan in water and never allow water to drip into the
motor housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
REMOVAL OF THE FRONT GRILLE FOR CLEANING
• Release the Front Grille clips from around the Rear Grille and remove the Front Grille.
• Unscrew the Blade Knob by turning it CLOCKWISE.
• Pull the Fan Blade away from the Motor Housing.
• Gently wipe the Fan Blade and Grilles.
• Re-assemble the fan by following the ASSEMBLY INSTRUCTIONS.
TO STORE YOUR FAN
Store your fan covered in a cool, dry place.
BREEZE
ON/SPEED
TIMER
uses 2 AAA
OFF
batteries
(included)