bloom fresco Armado Básico página 21

eng
• Never leave the child unattended when the
baby chair is in cradle mode.
• The child should be secured in the baby
chair at all times by the 5 point safety
harness in the reclining position.
• It is dangerous to put this cradle on an
elevated surface.
• Keep the cradle away from open fire,
heaters and other sources of strong heat.
• Do not use the cradle unless all components
are correctly fitted and adjusted.
• Make sure harness is correctly fitted before
use.
(b-b7) With Comfort Nest
Nest Pad & Safety Harness Assembly
– (#09) Pull open the storage compartment door
located on the inner face of the seat unit.
– (#04, #05) Put shoulder straps through the
nest pad slits at the desired height setting.
– Put waist straps through the nest pad side
slits, and the crotch strap through the bottom
slit.
– Behind the nest pad, slide the buckle on the
end of the shoulder straps into the buckle
slots located on the inner face of seat unit.
Check the straps are secured by pulling on the
straps.
– Behind the nest pad, slide the buckle on the
end of the waist straps into the buckle slots
on either side of the storage compartment.
Check the straps are secured by pulling on the
straps.
– (#16) From storage compartment, take out the
two 'U' shaped clips. Close the compartment
door.
4
– (#14) Put the crotch strap through the slit on the
comfort nest.
– Place the comfort nest into the seat unit, and
then press in towards the backrest.
– (#18) Place buckle on the end of the crotch
strap into the base of the comfort nest lock.
(The strap and buckle must not be twisted or
inverted. This will ensure correct locking of the
comfort nest lock.)
– Press button on the comfort nest lock, whilst
sliding the lock into seat unit.
– Snap the two 'U' shaped clips on either side of
the seat unit; you will hear an audible click.
– Adjust the length of the shoulder straps using
the buckle until it fits firmly around your child.
WARNING:
Always use the safety harness.
To remove the seat pad & safety harness for
cleaning, follow the instructions given in the care
& maintenance section of this instruction guide.
(b8-b4) Without Comfort Nest
Seat Pad & Safety Harness Assembly
– (#09) Pull open the storage compartment door
located on the inner face of the seat unit.
– (#11) Remove the comfort nest attachment
part from the storage compartment by
unscrewing the two screws with a philips head
screwdriver.
– Keep the comfort nest attachment part and
the screws in a safe place for future use.
– (#03, #05) Put shoulder straps through the