Hammerhead HCID120 Manual Del Usuario página 13

OPERATInG InsTRUCTIOns
6. Auto Hammer Adaptor
The auto hammer adapter permits the
tool to be used in the auto hammer
function.
When not in use, the auto hammer
adaptor provided with the tool
can be placed in the storage area
located on the base of the tool.
store the adaptor on the base of the
tool by snapping it into place.
7. Installing bits /
Auto Hammer Adaptor
a. Lock the variable-speed trigger
by placing the forward/lock/
reverse selector in the LOCKED
(center) position.
b. With one hand, pull the quick-
release 1/4" hex collet toward the
front of the tool and hold it in place.
c. With the other hand, insert a 1/4"
bit or the auto hammer adaptor
into the hexagonal opening in the
bit retainer.
d. release the quick-release 1/4" hex collet and check that it returns to its original position.

WARnInG: If the quick-release 1/4" hex collet does not return to its original position,
the bit or adaptor is not correctly installed. retry until the bit or adaptor is properly installed
and the quick-release 1/4" hex collet returns to its original position.
Removing bits /Auto Hammer Adaptor
a. Lock the variable-speed trigger by placing the forward/lock/reverse selector in the
LOCKED (center) position.
b. Pull the quick-release 1/4" hex collet towards the front of the tool and hold it in place.
c. remove the bit or adaptor from the hexagonal opening in the bit retainer.
d. release the quick-release 1/4" hex collet.

WARnInG: The bit may be hot after prolonged use. Use protective gloves when
removing the bit or adaptor from the tool, or first allow the bit to cool down.
COMPaCT IMPaCT DrIVEr/aUTO HaMMEr
6
7
13