Hammerhead HDHD060 Manual Del Usuario página 11

OPERATING INSTRUCTIONS
5. Auxiliary Handle
The tool must be supported with
the auxiliary handle, which can be
positioned and locked into any of
12 positions, 360° around the collar
mount.
To install the handle:
a. Unplug the hammer drill from the
power source.
b. Loosen the handle assembly
by turning the handle
counterclockwise.
c. Slide the handle assembly onto
the collar mount.
d. Rotate the handle assembly to the desired operating position, then push the handle
inward until it engages in the desired position.
e. Securely tighten the auxiliary handle by turning the handle clockwise.
To reposition the handle:
a. Unplug the hammer drill from the power source.
b. Rotate the lower portion of auxiliary handle counter-clockwise.
c. Push the handle forward until it disengages from the locking teeth in the collar
mount.
d. Move the handle to the desired position.
e. Push the handle inward until it engages in the desired position.
f. Securely tighten the auxiliary handle by rotating it clockwise.
6.0 AMP HAMMER DRILL
5
LOCKING
TEETH
AUXILIARY
HANDLE
CLOCKWISE
COUNTER-CLOCKWISE
11