Hammerhead HDHD060 Manual Del Usuario página 14

OPERATING INSTRUCTIONS
8. Removing Bits
WARNING: Use protective gloves
when removing the bit from the tool, or
allow the bit to cool down first. The bit
may be hot after prolonged use.
a. Unplug the hammer drill from
the power source.
b. Place the chuck key in one of
the three chuck key holes and
loosen the chuck by turning the
key counterclockwise.
c. Remove the chuck key.
d. Loosen the sleeve by hand.
e. Remove the drill bit.
9. Hammer/Drilling Selection Switch
When drilling in concrete, granite,
tile, marble, etc., push the selec-
tion switch to the side marked
with this symbol:
drilling.
To select drilling mode for drilling in
wood and metal, push the selec-
tion switch to the side marked with
this symbol:
14
for hammer
.
8
9
HAMMER/DRILLING
SELECTION SWITCH
CHUCK
KEY
6.0 AMP HAMMER DRILL