Hammerhead HDHD060 Manual Del Usuario página 12

OPERATING INSTRUCTIONS
6. Depth-Stop Gauge
The drilling depth can be pre-set and/
or repeated by using the depth-stop
gauge.
Unplug the hammer drill from the
power source and install the auxiliary
handle and make sure that the ac-
cessory has been fully inserted onto
the locking teeth on the chuck before
setting the depth-stop gauge.
To adjust the depth:
a. Unplug the hammer drill from the
power source.
b. Rotate the lower portion of auxiliary handle counter-clockwise to loosen the depth-
stop gauge.
c. Slide depth-stop gauge to the desired position.
d. Securely tighten the auxiliary handle by rotating it clockwise.
12
6
LOCKING
TEETH
DEPTH
-STOP
GAUGE
CLOCKWISE
X
COUNTER-CLOCKWISE
6.0 AMP HAMMER DRILL