Optional Setting; Channel Add/Delete; Picture Adjustment - Sylvania LD200SL8 Manual Del Usuario

O
PTIONAL SETTING

Channel Add/Delete

The channel add/delete function lets you add the channel that was not
added by the auto channel scan due to the reception status at the initial
setting. You can also delete the unnecessary channels.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K/L] to select "CHANNEL SETUP", then
press [ENTER].
or
3
Use [Cursor K/L] to select "ADD/DELETE(DTV)" or
"ADD/DELETE", then press [ENTER].
or
4
Select the channel you want to add or delete. (Refer to
"Channel Selection" on page 16.)
5
Use [Cursor s/ B] to select "ADD" or "DELETE".
or
• To add or delete another channels, repeat steps 4-5.
• Color of channel number displayed at the right top of
the TV screen indicates;
- Blue: The selected channel will be added.
- Red: The selected channel will be deleted.
6
Press [SETUP] to exit.
20
EN
e.g.) digital TV mode
- TV SETUP -
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
BACK LIGHT [BRIGHT]
COLOR TEMP. [NORMAL]
DTVCC
e.g.) digital TV mode
--- CHANNEL SETUP ---
ADD/DELETE (DTV)
AUTO PRESET CH (DTV)
AUTO PRESET CH (TV/DTV)
AUTO PRESET CH (CATV)
! CATV takes approx. 50min.
e.g.) digital TV mode
D25
ADD/DELETE : DTV
Note:
• "ADD/DELETE(DTV)" or "ADD/DELETE" menu will disappear
automatically in about 10 seconds.
• In the digital mode (DTV), you can add or delete channels
only for major channel.
• Once you delete a DTV channel, you cannot recover the
channel without performing auto channel scan again.
(Refer to "Auto Channel Scan" on page 14.)

Picture Adjustment

You can adjust brightness, contrast, color, tint and sharpness.
1
Press [PICTURE] to adjust the picture quality.
2
Use [Cursor K /L] to select the picture quality type you
want to adjust.
or
3
Within 5 seconds, use [Cursor s / B] to adjust the
quality.
or
Cursor
3
BRIGHTNESS to decrease brightness
CONTRAST to decrease contrast
COLOR
to decrease color
TINT
to add red
SHARPNESS
to make soft
4
Press [RETURN] to exit.
Note:
• The picture adjustment setting display will automatically
disappear in a few seconds.
[BRIGHTNESS]
[CONTRAST]
[COLOR]
[TINT]
[SHARPNESS]
Cursor
4
to increase brightness
to increase contrast
to brighten color
to add green
to make clear