Attaching A Wall Mount Bracket (Sold Separately) - Sylvania LD200SL8 Manual Del Usuario

Attaching a Wall Mount Bracket (sold separately)

The following is a description of the method for attaching a wall mount to this unit.
When performing this operation, refer to the instruction manual included with the wall mount kit.
You need the following wall mount kit for this unit.
Vision Mount LCD Mounts / model number: VMFb
For more information, please visit CSAV website at www.csavinc.com
#
CAUTION
• Any damage caused by incorrectly attempting to mount this unit is not covered under the terms of the manufacturers warranty.
• This LCD Color unit may be used only with VMFb manufactured by CSAV.
• Use with other wall mounts may result in instability causing possible injury.
* 1 and 2 indicate the
position of the screw holes
on this unit.
1) Turn this unit over and place it screen-first onto a
table which has a soft cloth draped over it.
Place this unit in a way so that the stand hangs over
the edge of the table.
Note:
• Make sure to use a table which can support the weight of this
unit and is larger than this unit.
• Make sure the table is in a stable location.
2) Remove the stands from this unit.
Unscrew the M4 screws indicated by
the stand.
Please be careful with the unit after you remove the
stand.
Note:
• The M4 screws and stand you have removed are necessary
for reattachment at a later date.
Make sure to keep them in a safe place.
3) Attach the monitor plate to this unit using the 4
bolts included with the wall mount kit.
You do not need to use the lock washers for
mounting this unit.
Note:
• Only use the screw holes indicated by
unit.
• For instructions on how to attach the monitor plate, refer to
the instruction manual included with the wall mount kit.
1
and remove
1
for mounting this
2
2
rear of this unit
ANT
HEADPHONE
Y Pb Pr L R
COMPONENT AUDIO
VIDEO 2
S-VIDEO VIDEO L R
COAXIAL
AUDIO
VIDEO 1
4) Attach this unit to the wall.
Note:
• Refer to the instruction manual included with the wall mount
kit when securing this unit to the wall.
* If you want to attach the stand of this unit again,
insert the stand slowly as illustrated below and drive
M4 screws in the 4 threaded holes (
1
stand
).
1
1
EN
9