Assembly & Set-Up - Troy-Bilt Horse Manual Del Operario

Tractor hidrostático de césped
Ocultar thumbs Ver también para Horse:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly & Set-Up
Assembly & Set-Up
Tractor Set-Up
Connecting the Battery Cables
CALIFORNIA PROPOSITION 65 WARNING:
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION: When attaching battery cables, always
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment
may have been left disconnected from the terminals at the
factory. To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
1.
Remove the plastic cover, if present, from the positive
battery terminal and attach the red cable to the positive
battery terminal (+) with the bolt and hex nut. See Fig. 3-1.
2.
Remove the plastic cover, if present, from the negative
battery terminal and attach the black cable to the negative
battery terminal (–) with the bolt and wing nut. See Fig. 3-1.
3.
Position the red rubber boot over the positive battery
terminal to help protect it from corrosion.
Figure 3-1
NOTE: If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed in the
Maintenance section of this manual prior to operating the
tractor.
Shipping Brace Removal
WARNING:
Make sure the riding mower's engine is
off, remove the ignition key, and set the parking
brake before removing the shipping brace.
Locate the shipping brace, if present, and accompanying
warning tag found on the right side of the mower, between
the discharge chute and the cutting deck. See Fig. 3-2.
While holding the discharge chute with your left hand,
remove the shipping brace with your right hand by
grasping it between your thumb and index finger and
rotating it clockwise.
Figure 3-2
WARNING:
The shipping brace, used for packaging
purposes only, must be removed and discarded
before operating your riding mower.
WARNING:
The mowing deck is capable of
throwing objects. Failure to operate the riding
mower without the discharge cover in the proper
operating position could result in serious personal
injury and/or property damage.
3
3
9

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

769-0435113ax61kg011

Tabla de contenido