Daitsu DS-9KIDB Manual Del Usuario página 12

Introduction for buttons on remote controller
Note:
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
● After putting through the power, the air conditioner will give out a sound.
Operation indictor "
models). After that, you can operate the air conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon "
on the display of remote controller will blink once and the air conditioner will give
out a "de" sound, which means the signal has been sent to the air conditioner.
● Under off status, set temperature and clock icon will be displayed on the display
of remote controller (If timer on, timer off and light functions are set, the corre-
sponding icons will be displayed on the display of remote controller at the same
time); Under on status, the display will show the corresponding set function icons.
1
On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
2
Mode button
Each time you press this button,a mode is selected in a sequence that goes from
AUTO, COOL, DRY, FAN, and HEAT *, as the following:
AUTO COOL DRY
3
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
Note:
● Fan speed under dry mode is low speed.
●
X-FAN function Hold fan speed button for 2s in COOL or DRY mode, the icon "
displayed and the indoor fan will continue operation for a few minutes in order to dry
the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF
●
button indoor fan will continue running for a few minutes. at low speed. In this
period, Hold fan speed button for 2s to stop indoor fan directly.
Having set X-FAN function off: After turning off the unit by pressing ON/OFF
●
button, the complete unit will be off directly.
4
▲ / button
Press ▲ / button to increase/decreaseset temperature. In AUTO mode, set
temperature is not adjustable. When setting Timer On or Timer Off, press "▲"
or " " button to adjust the time.
" is ON (red indicator, the colour is different for different
*
HEAT
FAN
* Note: Only for models with heating function.
"
" is