Daitsu DS-9KIDB Manual Del Usuario página 26

Installation of indoor unit
Note:
● Pay attention to dust prevention and
take relevant safety measures when
opening the hole.
● The plastic expansion particles are
not provided and should be bought
locally.
Step four: outlet pipe
1. The pipe can be led out in the
direction of right, rear right, left or
rear left.
right
1. Aim the pipe joint at the corresponding
bellmouth.
2. Pretightening the union nut with hand.
3. Adjust the torque force by referring to the following sheet. Place the open-end
wrench on the pipe joint and place the torque wrench on the union nut. Tighten
the union nut with torque wrench.
torque wrench
indoor pipe
4. Wrap the indoor pipe and joint of con-
nection pipe with insulating pipe, and
then wrap it with tape.
rear left
open-end
wrench
union nut
pipe
23
Indoor
5-10°
2. When select leading out the pipe
from left or right, please cut off the
corresponding hole on the bottom
case.
left
pipe joint
Hex nut diameter Tightening torque (N . m)
Φ 6
Φ 9.52
Φ 12
Φ 16
Φ 19
outdoor
Φ55
right
cut off
the hole
pipe
union nut
15~20
30~40
45~55
60~65
70~75
insulating pipe