For Service - Kenmore 402.4903 Manual De Uso Y Cuidado

BEFORE CALLING FOR SERVICE (CONT.)
H Water temperature control problem.
I-- (Heater Control problem) Call for service.
LIE Your Washer has tried to fill but has not reached
Call for service.
the proper water level.
I FI
I_1_t The door will not unlock.
C_I Motor not running properly.
,-,d
Your washer is not draining.
It can also mean that the unit senses a small
clog while draining.
Your Washer has tried to fill but was
unsuccessful.
,-,F
Check if the hot water supply hose is
connected.
I_1 The hot/cold water hose connection is not Please connect the hot/cold water hose connection correctly.
l--I i-- 1 correct.
OI-- Electric service was lost when Washer was Restart the cycle by pressing the Start/Pause Button.
I i-- running.
I-HZ A fault is detected in the water level sensor. Call for service
UI_
I--i
CIZ Jammed Key. Call for service
I _- Restart the cycle.
OiZ Motor speed sensor problem.
If the code reappears, call br service.
I I- Restart the cycle.
i_--iZ Temperature sensor problem.
If the code reappears, call for service.
_=H- Restart the cycle.
_jiZ High current detected.
If the code reappears, call br service.
Restart the cycle.
_=U- Call an electrician to check for electrical issues within the home
C C High/Low voltage detected.
before calling service.
If the code reappears, call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer, then turn it on
again. If the code reappears, call for service.
Restart the cycle pressing the Start/Pause Button. If the code
reappears, call for service.
Before calling for service, check the following.
loTurn off the unit and turn it on again.
2. Select only the Spin Cycle.
3. Press the Start/Pause to drain the water.
4. Clean the debris filter.
If it still does not drain, call for service.
Make sure the water faucets are open all the way. Check for
kinked hoses.
Check the inlet screens on the fill hoses.
You must connect the hot water supply hose because hot water
is supplied by the Auto Temperature Control (A.T.C.) function if
the temperature of the cold water is lower than 59°R
27
Kenmole-Washer-Ownels-Manual EN.indd 27 3,23,2010 3:12:29PM