GB
INSTALLATION
- It is recommended that, for your convenience, the appliance is positioned
close to your washing machine.
- The appliance must be installed in a clean place, where dirt does not build up.
- The appliance should not be located near a gas hob, cooker, heater or grill, as
flames from the burners could damage it.
- When installing the appliance, make sure that the power cord is not trapped
or twisted.
- The appliance is best operated around 25°C. Outside this temperature range,
performances may be affected.
- If it is necessary to move the appliance, it must be moved vertically.
- For better drying performance, keep the rear of the
appliance away from the wall.
- The appliance must not be installed behind a lockable
door, a sliding door or a door with hinges on the
opposite side to that of the tumble dryer, in such a
way that a full opening of the tumble dryer door is
restricted.
- To keep vibration and noise to a minimum when the dryer is in use, it should
be placed on a firm, level surface.
IMPORTANT:
The temperature of the hot air which can be emitted from the
tumble dryer can increase up to 60°C. The dryer must not be installed
on a floor which is not resistant to high temperatures.
Levelling the appliance
The dryer must be perfectly level to ensure safe and proper operation.
If the dryer is not properly level, adjust the levelling feet as necessary.
DO NOT insert pieces of wood or any other object under the feet.
If the appliance is installed on a carpeted floor, please adjust the feet
in order to allow air to circulate freely under the appliance.
Do not remove the feet. Do not decrease the floor clearance through
thick carpets, pieces of wood or equivalent. This can increase the
heat which can affect the operation of the appliance.
35