Kalorik AS 27222 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fax +1 305 430 9692
USING THE SLICER
For a safe use, your appliance is fitted with a sliding food platform (5)
with a thumb guard (1) and pusher (2)), which allows to protect your
hands by giving an exceptional use comfort.
The platform allows making to and fro motions along the blade to
cut the slices. Use the handle to move it.
The pusher allows you to hold the food in position when slicing by
holding your hand far from the blade. Therefore it is recommended
to always use it except if the food is too large and in this case keep it
as far as possible from the blade.
Clean all parts of the appliance before the first use.
Make sure the appliance is steady and add the pusher (2) on the
platform (5).
Plug in the appliance. The slicer is now ready for use.
Place a plate or a dish below the blade to collect the slices.
Move the platform away from the blade and lay the food to be
sliced on the stainless steel plate.
Push the food against the mobile side of the appliance with the
pusher (2) and select the slicing thickness – up to1/2" - by turning
the adjusting knob (6).
Place the switch (7) to the position I. The blade will start rotating
and the pilot light of the switch goes on.
Push the platform using your thumb on the thumb guard (1) to
bring the food to the blade (3). Therefore use the handle of the
platform and keep the pressure on the mobile side of the
appliance thanks to the pusher. Do not apply too much pressure,
for best results.
If it becomes difficult to slice the food (important braking of the
blade), move back a little bit and start the operation again by
approaching the blade slowly.
To avoid food sticking to the appliance and to improve the
slicing, you can moisten or oil the blade with a towel beforehand.
Do not slice meat with bones, food with large seeds, or rolled
roast without removing the string, wrappers (i.e. aluminium foil).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
5
Assembly page 5/24
AS 27222 – AS 29091 - 120501

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

As 29091

Tabla de contenido