GB
INSTRUCTIONS FOR ASSEMBLY AND USE
Unfolding the stroller
1
Release the storage latch
Grip the handle and lift it upwards
2
3
To lock the frame,lift handle as high as possible then,jerk upwards while placing one foot on
theframe lock
4
Attaching front wheels
• Push the front wheel axle into the hole on the plastic stand at the end of the front frame sup-
portleg until it fastens with a clik.
• Repet for the other wheel assembly.
• Check that the wheels are firmly attached by attempting to pull the wheels assembly off the
plasticstand.
5
Attaching rear wheels
• Push the hole in the rear wheel assembly onto the end of the rear tube until it fastens with a
click.
• Repeat for the other rear wheel assebly.
• Check that the wheels are firmly attached by attempting to pull the wheels assembly off the
rear tube.
6
Attention: Please make sure to attach left and right wheels onto the rear tubes.
7
Attaching bumper bar
• Insert the two bumper bar plugs into the holes at side armrest until it fasten with a click.
• Check that the bumper bar is firmly attached by attempting to pull it off the side armrest.
Attaching canopy
8
• Insert the canopy pin into the hole on the plastic situated on the interior side of the tube.
• Repeat the same action for the other side.
9
Front swivel wheels
• The front swivel wheels can be locked in the forward direction or unlocked to rotate freely.
• Move the hinged button up or down to lock or unlcok the wheel.
Leg rest adjustment
10
• Press up the two plastic parts at the end of leg rest downward with two hands and move the
legrest to the desired positioned.Note:Make sure both ends are at the same angle.
11
Backrest adjustment
• The backrest position can be adjusted among 3 positions.
• Press the two triggers towards middle to release the lock, and move the backrest to the
disiredposition.
• When postioning the backrest from the layback positon to the sitting position,simply move
thebackrest upwards,there is no need to use the triggers.
12
IM 1619,02 HOP ins.indd 12
06/05/13 18:41