Set-Up Instructions - NORTH STATES 8666 Instrucciones

SET-UP INSTRUCTIONS

Begin setting up your enclosure by
unsnapping the gray carrying strap and
carefully unfolding the panels to form a
hexagon, as shown in FIGURE 3 at right.
(NOTE: Model 8768 consists of eight
panels which will form an octagon when
set up properly).
When you have finished unfolding the
panels, there will be two unconnected
panels arranged as shown in FIGURE 4 at
right. Make certain that the dark gray
carpet foot (D) is up as shown.
Begin connecting the panels together by
gently lifting up on panel 1 and setting the
opening "A" (as shown in FIGURE 5) over
pin "B" located on panel 2.
Now locate the slot on the lower end of
cylinder "D" as shown in FIGURE 6. This
slot tapers to an opening that
accommodates pin "C".
Gently press down on panel 1 while
aligning pin "C" with the end of the slot in
cylinder "D". While maintaining downward
pressure on panel 1, lift slightly on panel 2,
and slide pin "C" through the slot and into
the opening as shown.
EXTENSION INSTALLATION
Two-panel extensions that are colored
appropriately for your yard are available
either from your dealer or direct from the
factory (see page 2).
The extension contains two additional
panels that enable you to expand the size
of your enclosure from 18.5 square feet to
34.4 square feet.
The extension is installed by following the
"SET-UP INSTRUCTIONS" that appear
above.
FIGURE 4
PANEL 1
P
FIGURE 5
PANEL 1 PANEL 2
OPENING A
PIN B
FIGURE 3
D
Dark
Gray
Car pet
PANEL 2
Foot
C
A B
FIGURE 6
PANEL 1
PIN C
Page 4
PANEL 2
SLOT IN
CYLINDER
D