marklin 151 Serie Manual De Instrucciones página 6

Function
• Possible operating systems: 6646/6647 Märklin Trans-
former, Märklin Delta, Märklin Digital, Märklin Systems.
• Recognition of the mode of operation: automatic.
• Addresses that can be set (Control Unit): 01 – 80.
Address set at the factory: 51
Name set at the factory: 151 023-9
• Adjustable acceleration/braking delay.
• Setting the locomotive parameters electronically with
the Control Unit, Mobile Station or Central Station.
• Built-in sound effects circuit, can only be used in
operation with the Control Unit or Märklin Systems.
WARNING! This product contains magnets. Swallowing This product contains magnets. Swallowing This product contains magnets. Swallowing
! ! ! ! !
more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain more than one magnet may cause death in certain
circumstances.
If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately. If necessary, see a doctor immediately.
6
Safety Warnings
• This locomotive is to be used only with an operating
system designed for it (Märklin 6646/6647 AC transfor-
mer, Märklin Delta, Märklin Digital or Märklin Systems).
Use only transformers rated for your local hosehold
!
power.
Do not under any circumstances use transformers
rated for 220 volts or 110 volts
• This locomotive must never be supplied with power
from more than one transformer.
• Pay close attention to the safety warnings in the
instructions for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for
this purpose.
The maintenance work necessary with normal operation
of this locomotive is described below. Please see your
authorized Märklin dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Märklin have been installed
in Märklin products or where Märklin products have been converted in
such a way that the non-Märklin parts or the conversion were causal to
the defects and / or damage arising. The burden of presenting evidence
and the burden of proof thereof, that the installation of non-Märklin parts
or the conversion in or of Märklin products was not causal to the defects
and / or damage arising, is borne by the person and / or company
responsible for the installation and / or conversion, or by the customer.