Qstarz BT-Q1200 Guía De Instalación Rápida página 3

Beyond Navigation
‐ When the Power LED is Red, battery power is low status. Please recharge.
‐ When the Power LED is Green, the battery is under charging mode.
‐ When the Power LED is blinking, the battery is fully charged.
F. Setup BT‐Q1200Ultra
F‐1 Install the USB Driver and software utility (Only support Microsoft
Windows XP / Vista)
Please insert the Driver CD to your computer, and find the folder "Utility\PC Utility
V4\". Double click "TravelRecorderV4_installer.exe" to install the software utility
package. This software package contains USB driver and PC Utility V4 software
inside.
F‐2 Install Google Earth
BT‐Q1200Ultra supports showing your travel path directly on Google Earth. Please
go to http://earth.google.com for the free download of Google Earth, and then
install it to your computer.
G. Start to use
G‐1 Fully charge the battery when using at the first time
A fully charged battery with solar power can last up to 48 hours continuously
operation (under optimum conditions and sufficient sunlight).
G‐2 Connect BT‐Q1200Ultra with your PC
Please connect BT‐Q1200Ultra with your PC by mini USB cable, and then
on BT‐Q1200Ultra and switch it to start logging
G‐3 Start the software utility
NOTE 1: Before starting the software utility, please make sure that the driver
and the software utility has been installed properly. And also, make sure
that BT‐Q1200Ultra already connect with your PC by mini USB cable,
power it on, and switch it to start logging or BT‐Q1200Ultra would enter
sleep mode after few minutes.
NOTE 2: PC Utility V4 only supports BT‐Q1200Ultra. Any intention to use PC
.
English
power
3