MZ electronic HC020 Instrucciones De Uso página 28

expressed in centimeters (or inches according to the measure set) is the value which has to be entered in
the Barbotin parameters
Setting the DIVIDER in the Sensor menu: if a standard sensor is used, this value must be set to
1 while using an electronic sensor it must be equal to the number of gypsy teeth:
Use
Press the (ON) key to activate controls and to switch on the display lighting. The display lighting
switches off 30 seconds after the last command given (adjustable default time – see "BkLight Time").
Press key (UP) to control the anchor ascending.
HC020
CIRCUMFERENCE OF THE BARBOTIN
28
Example:
Barbotin with 8 teeths
If a 3-wire electronic sensor is used, set this
value in the DIVIDER.
English
Rev. 01-2020