Measurement Reset - MZ electronic HC020 Instrucciones De Uso

English
Press key (DOWN) to cast anchor.
CHAIN UP CHAIN DOWN
m m
3.2 3.2
0 mt/m 0 mt/m
13.6V 13.6V
When any key is released (UP or DOWN) the corresponding action is stopped.

Measurement reset

To reset the measurement count simultaneously press the (ON) and the (UP) keys for at least
three seconds.
Measurement reset may also be performed in the Measurement menu by selecting "Yes" in the Reset
Measure row.
Automatic casting of the anchor
This function must be enabled in the Alarms and Functions menu (disabled by default).
Select the row "Auto Down" and set the value at which the anchor must stop. Then press the
(ON)
and (DOWN) keys for at least three seconds. Once anchor casting has commenced, release the keys.
For safety reasons it is however possible to interrupt automatic descent by pressing any
instrument key.
HC020 29 Rev. 01-2020