Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL DE INSTRUCCIONES
Internal oven tempe-
Temperature
rature.
set.
Run screen operating at one temperature.
Run screen operating with temperature
profile.
Fig 7.3.2 Working screen data.
J
.P. SELECTA s.a.u.
CÓDIGO 80381 REV A
OPERATION screen
There are two operation modes:
•
Working at a fixed temperature.
•
Working according to a pre-programmed temperature profile.
Press on
Operation at a temperature
•
Select the set point temperature by pressing on the temperature
indicator.
•
Select an operating time. This time starts to count down when the
temperature reaches the set point.
•
The INF value sets a continuous operation.
•
Start by pressing on this icon:
Operation with a temperature profile
•
Temperature profiles must be previously programmed from the
«PROGRAMMING» display.
•
Select a profile (from 0 to 9) by pressing on keys
•
Start by pressing on the icon:
•
In the temperature box (top-left corner), the current temperature
and the set point are indicated.
•
By pressing the graph icon you can switch the way of displaying the
temperature evolution data either in graphical form or in a table format.
Step target
temperature
Current
temperature
* Point 1 (top) indicates the status of the oven:
. if it flashes red, the heating works.
. if it is yellow (only in programs) it indicates that the stove is in
the resting phase (waiting to reach the heating phase).
* Point 2 (lower) indicates the data log:
. if it flashes green, it indicates that data logging is activated.
. if it flashes white, it indicates the frequency of data recor- ding,
or what is the same, the recording interval.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail:selecta@jpselecta.es - web site: www.jpselecta.es
FEBRERO 2020
to change the operation mode.
.
.
*
*
Program:
Nº step on running.
Pag.: 24
Current step duration:
Total elapsed time of the
current step:
Tel 34 937 700 877 Fax 34 937 702 362
Publicidad
Tabla de contenido
