Installation of entrance panel (type 13K1), flush-mounting version
- Install the flush-mounting back box (D) on the wall with the bottom edge at
a height of approx. 1.65m from the ground
- Open the entrance panel by undoing the screw under the plate (G) and
detach the camera (B) from the frame, removing the light diffuser (h) and
the microphone (I).
- Fit the frame (C) to the flush-mounting back box (D)
- Reposition the camera in the frame and the microphone in the special
housing, refitting the plug as shown in fig.16A.
- Connect the camera to the name card lighting LED board using the two
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if
required) fig.16B.
- Make the connections to the installation on the removable terminal block
(L). In the case of installation for two-family video door entry systems:
- Remove the blanking module (E) fig. 17, from the back of the plate using
a screwdriver, working in sequence from bottom to top (first remove the
end section, then key 1 and finally the blanking module).
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
- Fit the external key (F) (supplied) to the plate by pushing it lightly into
ESECUZIONE DA INCASSO PARETE
place.
- Insert the light diffuser (h) to ensure even lighting of the name cards.
- Close the entrance panel, securing it to the frame with the aid of a screw-
driver.
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
Fig.15
A
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
B
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
C
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
D
MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE
12
Fig.16A
UNA TARGA CITOFONICA
UNA TARGA CITOFONICA
Fig.17
G
UNA TARGA VIDEOCITOFONICA
UNA TARGA VIDEOCITOFONICA
h
L
I
M
4
UNA TARGA DA INCASSO PARETE
N
3
UNA TARGA DA INCASSO PARETE
Installation of entrance panel (type 13K1), surface wall-mounting version
- Open the entrance panel by undoing the screw under the plate (G) and
O
detach the camera (B) from the frame, removing the light diffuser (h) and
the microphone (I).
- Install the frame (C) together with the surface wall-mounting back box (P)
on the wall with the bottom edge at a height of approx. 1.65m from the
ground.
- Reposition the camera in the frame and the microphone in the special
housing (B), refitting the plug as shown in fig. 16A.
- Connect the camera to the name card lighting LED board using the two
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if
required) fig.16B.
- Make the connections to the installation on the removable terminal block
(L).
In the case of installation for two-family video door entry systems:
Red/black cable
ESECUZIONE DA ESTERNO PARETE
Green/green cable
ESECUZIONE DA INCASSO PARETE
2
1
Fig.16B
12V
LED Ch2
Art. R130)
(
E
(
Art. R135)
F
EN