Basic Operations; Switching The Power On/Off; Volume Setting - Dynascan P-72 Manual De Instalación

♦ Speaker-microphone input mode:
1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to switch to VFO mode.
3. Enter the desired frequency by using the numbers (0~9) on speaker-microphone keypad.
LCD display for direct frequency entry showing:
Note:
- If the [PTT] or [MENU] knob is pressed before all the digits are entered, the remaining
digits are set to "0".
♦ Shift input mode:
1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to switch to VFO mode.
3. Press the [MENU] knob, then press the [VFO/MR] key.
● The "Hundred digit MHz" of the currently selected operational band (CTRL) we flashes.
4. Rotate the [MENU] knob to select the input digit, or input the number through the speaker-
microphone keypad.
● Press the [SQL/MONI] key to move the cursor to the left by one digit, or the [TONE/T.SEL] key
to the right by one digit. When the shift is selected, the previous digit is automatically confirmed.
5. After selecting, press the [MENU] knob to confirm.
● The setting will be confirmed automatically if 5 seconds without performed any operation or you
can press the [B/E] key to confirm the setting and exit.
7.- BASIC OPERATION:

7.1.- SWITCHING THE POWER ON/OFF:

1. Press and hold the [ON/OFF] key for more than 3 seconds to turn ON the transceiver.
● Power on message displays briefly on the screen.
2. Press and hold the [ON/OFF] key for more than 3 seconds to turn OFF the transceiver.

7.2.- VOLUME SETTING:

1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VOL/SCAN] key.
● The "VOL" icon displays on the right side of the band.
3. Turn the [MENU] knob to select the volume output level from 00 to 20.
● If set to "00", the current band volume output is the minimum.
● If set to "20", the current band volume output is the maximum.
4. After selecting, press the [MENU] knob to confirm or press the [B/E] key to cancel the setting.
English - 18 -