Select The Operating Band / Display Mode; Calling Channel Mode; Transmitting - Dynascan P-72 Manual De Instalación

7.7.- SELECT THE OPERATING BAND / DISPLAY MODE:

After saving the memory channel, the transceiver can switch between the memory channel and the
stored frequency. This is useful for confirming the frequency stored in the memory channel.
1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to select the displaying mode from the following four modes:
● VFO (Frequency display) mode.
● Channel & Frequency mode.
● Channel mode.
● Channel & Name mode.

7.8.- CALLING CHANNEL MODE:

Calling cannel mode allows selecting a preset channel to call immediately. It can be easily used as
an emergency channel.
1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [CALL/C.IN] key to call out the saved calling channel.
● The "C" icon appears on the screen of the current band.
● Press the [PTT] and then speak into the microphone to transmit.
3. Press the [CALL/C.IN] key again to exit the calling channel mode and return to the previous
operating mode.

7.9.- TRANSMITTING:

1. Press the [PTT/CLR] key to select the desired transmitting band.
● The band with the "PTT" icon appearing above can be transmitted.
2. Press the [PTT] and then speak into the microphone to transmit.
● The
icon displaying on the transmitting band, indicates the relative transmitting power.
● The "L" or "H" icon will display in the upper of the band depending on the selected output
transmission power.
● Speak into the microphone with normal voice, and keep the microphone about 5 cm far away
from your mouth. Speak too loud or keep too close to the Mic will increase the signal distortion and
decrease the intelligibility.
3. After speaking, release the [PTT] to receive.
English - 21 -