To Store Frequency On Memory Channel - Dynascan P-72 Manual De Instalación

Notes:
- While using the reverse function, if the TX frequency exceeds the allowable transmitting
frequency range, press the [PTT] will result in transmitting prohibited.
- While using the reverse function, if the RX frequency exceeds the allowable receiving
frequency range, the reverse function will fail to use.
- While using the reverse function, if there is no offset frequency, the reverse function will
fail to use.
- While using reverse function, if there is no offset direction, the reverse function will fail to
use.
- While on transmitting, the reverse function will fail to turn ON or OFF.

9.7.- TO STORE FREQUENCY ON MEMORY CHANNEL:

1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to select the VFO mode.
3. Rotate the [MENU] knob, or input the desired frequency through the microphone keypad.
● Besides, the user could change the frequency with preset step frequency by press the [UP] /
[DOWN] keys on microphone.
● If necessary, you can preset the parameters mentioned below for the channel you want to stored.
Offset direction (+/-), enable or disable the CTCSS/DCS, setting the CTCSS tone or DCS code.
4. Once the setting is finished, press and hold the [VFO/MR] key for 3 seconds.
● The memory channel number will show up and flashed at the right of the currently operation band
(CTRL).
5. Rotate the [MENU] knob to choose the desired channel number for storage.
6. After selection, press the [MENU] knob to confirm the selected frequency and parameters saved
on the memory channel.
● "Saved" will display on the screen once the program is completed, or press the [B/E] key to
cancel the storage and return to standby mode.
English - 31 -