Turn On/Off The Ctcss/Dcs; To Choose Ctcss Tone Or Dcs Code - Dynascan P-72 Manual De Instalación

9.4.- TURN ON/OFF THE CTCSS/DCS:

1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to select the VFO mode.
3. Press the [TONE/T.SET] key to cycle select the tone type or turn OFF the tone.
● Every press the [TONE/T.SET] key the options will be changed as below: → QT → DOT →
OFF → ON.
● When the CTCSS/DCS signaling is activated; "QT" will be displayed on the screen.

9.5.- TO CHOOSE CTCSS TONE OR DCS CODE:

1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [VFO/MR] key to select the VFO mode.
3. Press the [TONE/T.SET] key to select the tone type (CTCSS/DCS).
4. Press and hold the [TONE/T.SET] key for 3 seconds to access CTCSS tones or DCS codes.
● Once the CTCSS/DCS is activated, settings can be operable.
5. Rotate the [MENU] knob to select the CTCSS tone/DCS code, or press the [TONE/T.SET] key
to choose the CTCSS tone/DCS code for RX or TX or RX+TX.
● Every press the [TONE/T.SET] key the options will be changed as below:
>> CTCSS: RX&TX_CT (RX+TX) → RX_CT → TX_CT.
>> DCS: RX&TX_DCS (RX+TX) → RX_DCS → TX_DCS.
6. Press the [MENU] knob to confirm the current operation, or press the [B/E] key to cancel and
back to standby mode.
Note:
- If the memory channel to be programmed with CTCSS/DCS, then just need to call the
memory channel rather than to program the CTCSS/DCS every time.
English - 29 -