Care And Cleaning; Troubleshooting - HAMPTON BAY HB-7900-02 Guía Para El Uso Y Cuidado

Operation (continued)
3
Selecting a push button tune
The doorbell (A) has different selectable tunes for
push buttons (sold separately). The push button set
as the "REAR" push button will only play Ding (one
note tune). The push button set as the "FRONT" push
button will play either Ding-Dong (two note tune) or
Westminster (eight note tune).
Press and release the "TUNE" button on the
doorbell (A) until the desired tune is heard.
NOTE: All doorbell models are designed to work with up
to 10 wireless push buttons (sold separately).
Doorbell tune

Care and Cleaning

Use a dry cloth to clean the doorbell and sensor.
Do not use cleaners or polishes.
Do not use any fluids on the doorbell or sensor.

Troubleshooting

Problem Possible Cause
Doorbell does not
sound.
Door alert
Beep-Beep
Batteries not installed
correctly.
Batteries are dead.
Doorbell is not receiving
power.
Sensor and doorbell are
not synced.
NOTE: All doorbells are designed to play only two
different tunes no matter how many push buttons are used.
Front door push button
(sold separately)
Ding-Dong or Westminster
Solution
Make sure batteries are installed according to the
diagram inside the sensor.
Check the charge of the sensor batteries and replace if
necessary.
Make sure the plug-in doorbell has power.
Sync the sensor and doorbell:
Remove the sensor back using a small flathead
screwdriver.
Press and hold the button on the doorbell until the
doorbell sounds a "Beep-Beep".
Press the button inside the sensor within 30 sec-
onds. The doorbell will sound a "Beep-Beep" tone to
indicate the sensor is synced.
Test the sensor as shown in step 3 under Installa-
tion to ensure operation.
7
Please contact 1-844-760-3644 for further assistance.
A
Rear door push button
(sold separately)
Ding
HAMPTONBAY.com