Standard Accessories; Prior To Operation - Hitachi Koki CM 4SB2 Instrucciones De Manejo

English
35. Proceed with cutting operation when full speed has been
reached.
36. Do NOT apply excessive force.
37. When cutting concrete, tile, or stone, the maximum
cutting depth should be held to within 20mm.
38. Never touch diamond wheel while operating.
39. Never lay down the cutter while the diamond wheel is
revolving.
40. Exercise care to position the cutter at a safe, stable spot
when cutting.
SPECIFICATIONS
Voltage (by areas)*
Power Input*
No-Load Speed
Max. cutting depth
Diamond wheel
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always wear hearing protection.
Class II tool

STANDARD ACCESSORIES

(1) Water Plug (with machine screw) ..................................1
(2) Box Wrench ..................................................................1
(3) Wrench .........................................................................1
(4) Rubber Connector ........................................................1
(5) Vinyl Hose .....................................................................1
5
1
Standard accessories are subject to change without notice.
6
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
110 mm external dia. × 1.0 mm thickness × 20 mm internal dia.
4
2
3
41. Take good care of the power tool and keep it clean.
42. When wheel is binding or when interrupting a cut for any
reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop.
Never attempt to remove the cut-off wheel from the cut
while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the
cause of wheel binding.
1320 W
11500 /min
34 mm (wheel dia. 110 mm)
31.5 mm (wheel dia. 105 mm)
2.8 kg
OPTIONAL ACCESSORIES (sold separately)
Diamond Wheel
A Type
Diameter
(mm)
A (Dry)
Blade
type
B (wet)
Optional accessories are subject to change without notice.
APPLICATIONS
○ Cutting and scribing of concrete.
○ Cutting and scribing various types of stones.
○ Cutting and scribing various types of tiles.

PRIOR TO OPERATION

1. Confi rming the earth leakage breaker or isolating
transformer
Before using this Cutter, confi rm that an earth leakage
breaker or isolating transformer as electric shock
preventive measures is installed at the power supply to
which the Cutter is connected.
2. Power source
Ensure that the power source to be utilized conforms to the
power requirements specifi ed on the product nameplate.
3. Power switch
Ensure that the power switch is in the OFF position. If the
plug is connected to a receptacle while the power switch
is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
B Type
Hole
Thickness
diameter
(mm)
(mm)
106 20
110 20
1.2
1