Tool it TBP 500 Manual De Usario página 4

TEST OF THE LOAD CIRCUIT
1. Connect the TBP 500 as for the test of the battery's state.
2. Start the engine of the car so that it reaches its normal temperature of operation.
3. Make turn the engine between 1200 and 1500 turns.
4. Read the results on the scale "ALT&REG.TEST "of the monitor to the right-hand side.
If the needle is in the red part "LOW", there is a problem in the load circuit.
If the needle is in the red part "HI", the load circuit probably causes on the overload of the batter
TEST OF THE CIRCUIT 12V STARTER
This makes to know if there is a starter current excessive problematic for starting and being able to generate a reduc-
tion of the battery's lifespan.
With this intention, the battery must be assembled in temperature.
1. The red clamp is on (+) of the battery; the black clamp is on (-).
2. Start the engine and note the tension on the monitor to the right-hand side during the starting.
3. If the tension is ≤ 9 Volts, the current is too high. That can be due either to bad connections, either to the failure
of the starter, or with the size of the too weak battery compared to the needs of the car.
4
TBP 500
EN