Troubleshooting - GMC GMBL18ID Manual De Instrucciones

Atornillador de impacto sin escobillas 18v
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34

Troubleshooting

Problem
Green LED (13) and Red LED (14) do not illuminate to indicate the
Battery (9) is correctly charging
Battery pack has low capacity
Impact driver cannot be switched on (Trigger Switch (6) does not move)
Impact driver does not start when Trigger Switch is depressed
Possible cause
Battery not correctly connected to Battery Charger (12)
Battery Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times and capacity has
started to reduce
The Forward/Reverse Switch (5) may be in the middle ('locked')
position
Battery completely discharged
Defective Battery
Tool defective
9
Solution
Clean battery socket of Battery Charger and Battery contacts and fully
slide on to charger so it clicks in a locked position
Recheck mains connection
Do not remove Battery until a full charge is indicated
This is normal for battery packs. Contact your GMC dealer to purchase a
replacement battery pack
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged Battery
Replace Battery
Contact your GMC dealer or authorised service centre
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido