Ingeteam INGEREV CITY Duo Manual De Usario página 10

Ingeteam
By default, this variable is defined by the maximum current of each outlet, which is indicated on the charging
station's specification plate. Its value must be a positive, whole number.
It is recommended that the minimum value for this variable matches the maximum current for an outlet.
Example:
input_current = 32;
nominal_current_outlet1
Current settings sent to the vehicle connected to outlet 1.
By default it is the nominal current that shows on the charging station specification plate. Its value must be a
positive, whole number.
Its bottom limit is 6 Amps according to regulations and its top limit is the same as the current of the specification
plate.
For ZE Ready units, the bottom limit is 7 Amps for single-phase versions and 13 Amps for three-phase versions.
If compliance with these ranges is not met its previous value will be preserved.
Example:
nominal_current_outlet1 = 15;
nominal_current_outlet2
Current settings sent to the vehicle connected to outlet 2.
By default it is the nominal current that shows on the charging station specification plate. Its value must be a
positive, whole number.
Its bottom limit is 6 Amps according to regulations and its top limit is the same as the current of the specification
plate.
For ZE Ready units, the bottom limit is 7 Amps for single-phase versions and 13 Amps for three-phase versions.
If compliance with these ranges is not met its previous value will be preserved.
Example:
nominal_current_outlet2 = 15;
start_deferred_charge
Enables the start time of the deferred charge to be programmed. This variable is disabled by default.
To program the start of the deferred charge, a operator.ini file must be uploaded with a variable that has a valid
time programmed.
The format of the variable is 24 hours, set as follows hh:mm:ss.
Example:
start_deferred_charge = "23:05:00";
To disable the end of the deferred charge a operator.ini file must be uploaded containing an empty variable.
Example:
start_deferred_charge = "";
finish_deferred_charge
Enables the end time of the deferred charge program to be programmed. This variable is disabled by default.
To program the end of the deferred charge a operator.ini file must be uploaded with a variable that has a valid time
programmed.
The format of the variable is 24 hours, set as follows hh:mm:ss.
Example:
finish_deferred_charge = "09:55:00";
To disable the end of the deferred charge a operator.ini file must be loaded containing an empty variable.
10
Folder system
ABA2020IQM05_A - Configuration