American Standard Townsend 2691 Instrucciones De Instalación página 3

5
Install drain per instructions provided with Drain Kit 1582.000.YYY.
Drain Kit 1582.000.YYY purchased separately.
6
INSTALLING THE 1-1/2" (38mm) DIAMETER TAIL PIECE ASSEMBLY INTO P-TRAP
8" (203mm) tail piece included with Drain Kit 1582.000.YYY.
A slip-joint nut and a flanged, 1-1/2" (38mm) diameter tail
piece are recommended. (See Fig. 3)
Slide the slip-joint nut over tail piece towards the flanged
end as shown.
Slide the P-trap slip-joint nut and seal over the tail piece
as shown.
Insert the tail piece into the P-trap.
The flange of the tail piece should be approximately
2" (51mm) above the finished floor when fully inserted
to the P-trap.
The tail piece can be cut if necessary.
7
Carefully set the tub into position using the outline on the floor as a guide.
Connect the tailpiece to the tub drain. Tighten all of the drain connections.
8
Fill the tub with water and drain. Check for leaks and re-tighten connections as necessary.
9
Apply a bead of Tub & Tile caulk around the bottom edge of the tub where it meets the floor.
Remove any excess caulking.
TAIL PIECE
ASSEMBLY
2"
(51mm)
FINISHED
FLOOR
P-TRAP
SLIP-JOINT
NUT & SEAL
(PROVIDED BY
INSTALLER)
3
THREADED PORTION
OF DRAIN BODY
SLIP-JOINT NUT
TAIL PIECE
P-TRAP
(PROVIDED BY
INSTALLER)
FIG. 3
755423-100 Rev. 1 3/19