RDI transform Instrucciones De Instalación página 11

21.
Loosen the tensioner so that approximately
5 or 6 threads are showing and then push
the cable into the fitting, rotating the fitting in
the direction shown (Fig. 36). Once the cable
has bottomed out in the fitting, pull the cable
away from the post to help set the locking
mechanism to lock the cable into the fitting
(Fig. 37).
NOTE: Full insertion of the cable is
CRITICAL to fitting performance under
tension! Cable CAN be removed at this
point using the cable release key (sold
separately, item 73025484).
22.
Tension the cable by holding the cable-gripping
portion of the fitting stationary (Fig. 38 - a),
using a 3/8" wrench as you rotate the female
threaded portion of the fitting with a separate
3/8" wrench (Fig. 38 - b).
Tension all cables to desired amount in
sequence, beginning with the center cables,
moving up and down toward the top and
bottom (Fig. 39). As you tension each cable,
give it a sharp pull downward mid-span to help
set the wedges, then re-tension as necessary
in the same sequence.
NOTE: Cable can NOT be removed once
tensioned!
(Fig. 36)
a
(Fig. 37)
b
(Fig. 38)
(Fig. 39)
12
10
8
6
4
2
1
3
5
7
9
11
11