Setup; Setup Location Requirements; Avoiding Radio Interference - CASO DESIGN CM1000 Manual Del Usuario

13.5 Setup

13.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:

The device must be set up on a firm, flat, horizontal and heat-resistant
surface with sufficient load-bearing capacity for the oven and the maximum
weight of the expected food that is to be prepared in the oven.

Choose the setup location in such a way that children cannot reach any hot
surfaces on the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or
near flammable material.

The device requires an adequate flow of air in order to operate correctly.
Leave a clearance of 10 cm above the oven.

Do not cover up any openings on the device and do not block these off.

Do not remove the device's adjustable feet.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations
(e.g. on ships) must be carried out by specialist companies / electricians,
provided they guarantee the prerequisites for the safe use of this device.
13.5.2

Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:

Clean the door and the sealing surfaces of the device.
caso CM1000 39