Electrical Connection - CASO DESIGN CM1000 Manual Del Usuario

13.7 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:

Before connecting the device, compare the connection data (voltage and
frequency) on the rating plate with those of your electrical network. This data
must agree in order that no damages occur in the device
If in doubt, ask your qualified electrician.

The electrical outlet must be protected by a 16A safety cut-out switch.

The connection between the device and the electrical network may employ a
3 meter long (max.) extension cable with a cross-section of 1.5 mm². The
use of multiple plugs or gangs is prohibited because of the danger of fire that
is involved with this.

Make sure that the power cable is undamaged and has not been installed
under the oven or over hot or sharp surfaces.

The electrical safety of the device is only guaranteed if the device is
connected to a properly installed protective conductor system. Operations
using an electrical outlet without a protective conductor are prohibited. If in
doubt, have the house installation checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused
by a missing or damaged protective conductor.
caso CM1000 41