GYS GYSFLASH 30-12 HF Manual Del Usuario página 13

Voltage adjustment:
It is possible to adjust the voltage from 12 to 14.8V in increments of 0.1V according to the vehicle
manufacturers' specifications:
SHOWROOM MODE CONFIGURATION
SHOWROOM
SHOWROOM
Power Supply with battery:
Connect the clamps: red (+)
SHOWROOM MODE START UP
and black (-) of the battery.
• Push the Start/Stop button.
SHOWROOM
SHOWROOM
• During use, the current
consumed and the
instantaneous voltage are
displayed.
Power Supply without battery (not-recommended):
It is possible to supply the vehicle without battery by pushing the "START/STOP" button for 3
seconds. The screen displays "no battery" for 1 second before starting to supply the vehicle.
Warning : Reverse polarity could damage the vehicle's electronics.
Precaution: Before using the Showroom Mode. If the screen displays a current higher than 10A, it
indicates the battery is discharged. The device will start charging automatically. Check all electrical
consumers are switched off on the vehicle. Wait until the current falls below 10A before using the car
electronics.
BATTERY CHANGE MODE
The GYSFLASH ensures a stabilised power supply to the vehicle during battery replacement to
preserve memory settings.
Voltage selection (only for the GYSFLASH 30-24HF):
On the GYSFLASH 30-24HF, it is possible to select 12V or 24V to change the battery:
BATTERIE CHANGE MODE CONFIGURATION
CHANGE BATTERY
CHANGE BATTERY
13