Configuration Menu; Automatic Restart - GYS GYSFLASH 30-12 HF Manual Del Usuario

Instructions:
• Connect :
1 : The black clamp to the vehicle chassis.
2 : The red clamp to the end of the lug connected to the "+" battery terminal, in such a way that the
battery can be changed without disconnecting the clamp.
• Press the START/STOP button.
• During use, the current
consumed and the instantaneous
voltage are displayed.
• When changing the battery ensure the polarity is correct. While exchanging the batteries, be careful
not to disconnect the charger clamps as it can cause the loss of electronic data.
Caution: polarity reversal can be harmful to the vehicle electronics.

CONFIGURATION MENU

Access to configuration menu:
Press the "Mode" button for 3
seconds
To access to the sub menu press the "Select" button :
languages > restart > lock showroom > cables testing
Sub menu:
Languages :
This menu allows selecting the language.

Automatic restart :

Automatic restart only works with "Showroom" Mode and "Charge" Mode. This feature allows in
case of power cut the charger to restart automatically and to restart charging automatically.
This feature is set as default => Display "Configuration | Restart : ON".
Lock Showroom :
To lock the device on Showroom Mode (to avoid mishandling)
Shortcut to Lock Showroom :
The "Lock Showroom" feature can be activated without accessing the configuration menu.
• Turn the device off (Switch to the OFF position)
• Push the MODE button
• Turn the switch ON, while the MODE button is still pressed. The screen displays
"GYSFLASH 30-12HF Vx.x" or "GYSFLASH 30-24HF Vx.x" for 3 seconds.
• Hold the MODE button unit the screen displays "lock showroom: Y"
Cable calibration :
This mode must be used each time the cables are changed. The GYSFLASH can be fitted with
cables up to 2x5m in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory
setting. Check that the cables are in good condition and properly put in short-circuit and repeat the
procedure.
Push the "MODE" button to exit the "Configuration" sub menu.
14
B
ATTERY CHANGE MODE START UP
CHANGE BATTERY CHANGE BATTERY