GYS GYSFLASH 30-12 HF Manual Del Usuario página 12

NB: When the charge ends (100%), if the battery remains connected the charger maintains the
charge level of the battery by applying a floating voltage.
Precaution: Check the electrolyte level and fill if necessary before charging.
DIAG MODE AND DIAG+ MODE
On a stationary vehicle, the GYSFLASH supplies up to 30A to ensure compensation of the current used
by high-energy consumers (engine fan, window regulator, electronic suspension, etc...) by charging at
a steady voltage:
- 13.5V (Diag Mode)
- 12V to 14.8V , user defined (Diag+ Mode)
Voltage adjustment (only in Diag+ Mode):
The Diag+ Mode allows user to specify the voltage delivered to the battery from 12 to 14.8V in
increments of 0.1V according to the manufacturers' specifications:
Start up :
• Connect the clamps: red (+)
and black (-) of the battery.
• Push the Start/Stop button.
• During use, the current
consumed and the instantaneous
voltage are displayed.
Precaution: Before using the Diag Mode. If the screen displays a current higher than 10A, it
indicates the battery is discharged. The device will start charging automatically. Check all electrical
consumers are switched off on the vehicle. Wait until the current falls below 10A and then re-launch
the diagnostic.
SHOWROOM MODE
On a stationary vehicle, the GYSFLASH supplies up to 30A to ensure compensation of the current used
by high-energy consumers (engine fan, window regulator, electronic suspension, etc...) by charging at
a steady voltage adjustable from 12V to 14.8V
12
+
DIAG MODE CONFIGURATION
+
DIAG
+
DIAG
DIAG MODE START UP
DIAG DIAG