Network Connection - Xerox Phaser 6115MFP Guía De Configuración De Funciones

Network Connection

Use an Ethernet connection with two twisted-pair (Category 5/RJ-45)
cables and an Ethernet hub or router. If your computer is on a large
network, contact your network administrator for the appropriate TCP/IP
addresses and additional configuration information.
Note: You cannot scan to applications or use the MCC software over a
network connection.
Local Area Network
A Local Area Network, or LAN, is a collection of computers, printers,
and other devices connected to share information. The most common
LAN uses Ethernet and the TCP/IP protocol to provide communication.
■
TCP/IP requires all devices to have a unique IP Address, similar to
the way telephone numbers are unique.
■
IP addresses can be assigned Manually (Static) by the user.
■
IP addresses can be assigned Automatically (Dynamic) by a
DHCP Server, which is built into a router. A valid IP address is
obtained from the DHCP Server when you connect your Xerox
product to the LAN.
For more information on networks and protocols, see the User Guide.
Manually Setting the Product's IP Address
1. On the control panel, press the Menu/Select button.
2. Using the Up Arrow or Down Arrow button, scroll to Network
Setup, and then press the Menu/Select button.
3. Using the Left Arrow or Right Arrow button, select Static, and
then press the Menu/Select button.
4. Scroll to IP Address, and then press the Menu/Select button.
5. Enter the IP Address using the numeric keypad.
6. Press the Menu/Select button to save the IP address.
7. Follow the above steps to set the Subnet Mask and Gateway
addresses, if necessary.
Phaser® 6115MFP Multifunction Product
EN - 4
Network Connection