Cleaning - Krups KB790 Manual De Instrucciones

To add ingredients while blending, carefully remove the lid stopper from
■
the center of the lid and add ingredients through the opening. Replace
the lid stopper once ingredients have been added.
If you wish to scrape down the slides of the jar, press OFF and unplug
■
the appliance before removing the blender jar from the base. Never
reach into the blender jar with the jar still on the base.
Unlock the lid and use a plastic spatula to scrape down the sides. The
blades at the bottom of the blender jar are very sharp, take care when
scraping the jar to not damage your tools.
Never
put hands or fingers into the glass jar or close to the blade.
■
Always start blending on the lowest speed then increase to the
■
desired speed.
Remove the blender jar from the metal base only when it has come to
■
a standstill.
Cord storage: The power cord can be shortened by feeding back into
■
the metal base through the opening in the rear

CLEANING

Always turn the blender off and unplug, then remove the blender jar
■
from the base before cleaning.
Wipe the metal base with a damp cloth and dry before using.
■
Never immerse the base in water or place under running water.
■
Do not clean base with harsh or abrasive chemical cleaners or sponges.
■
■ The blender jar and lid can be washed in the dishwasher. The
blender lid should be washed on the top rack only to prevent
deformation.
When washing by hand, use warm water and a gentle dishwashing
■
liquid.
Always remove the blade assembly from the bottom of the blender jar
■
before washing.
To clean the blade assembly, empty the jar and hold upside down, with
■
the locking ring base on top, then release the locking ring base, and
carefully remove the blade assembly and seal from the locking ring
base.
English
(diagram 4)
.
10