Removing The Bassinet; Troubleshooting - BabyCargo PLUSH + PLAY Manual De Instrucciones

11

REMOVING THE BASSINET

• Detach Rigging Clips in reverse order from setup: long- and short-rail
center Clips first, corner Clips last.
• Lift the Bassinet (Cradle with Mattress) out of, then away from
the Playard.
• Flip the Bassinet Cradle upside down, so the underside of the Cradle
Assembly is exposed. Decouple the Mattress's Velcro straps and tabs,
guiding the straps back through their slots. Flip the Assembly rightside
up, then lift the Mattress out.
• Disconnect each pair of Structural Support Poles, and remove each pole
from its sleeve.
• Store the Bassinet Cradle Assembly and Structural Support Poles
together in the Carrying Bag for safekeeping.

TROUBLESHOOTING

Issue: Bassinet sags in the middle when baby is placed on it.
Common Cause: The Structural Support Poles on the floor of the
Bassinet Cradle Assembly are missing, or are not installed properly.
Solution:
• When baby is no longer in the Bassinet, remove the Cradle and
Mattress from the Playard.
• Remove the Mattress from the Cradle Assembly.
• Check the Bassinet Cradle Assembly floor. Make sure each Structural
Support Pole is rigid and secure by checking to make sure the lock-
pin has popped into place.
• If Structural Support Poles are not installed, follow steps two through
five above. If Poles are missing, contact BabyCargo at 1-800-732-0914
for a manufacturer's replacement.